![]() ![]() I suppose another approach would be to just fill an 8 sec buffer in memory from your callbacks, and when it's full, have another thread write that file while you malloc a new buffer and start recording into that (obviously, the file writer would dispose the old buffer when it's done).Įdit: Also, I didn't see anything about Swift in your question, but any of this should work fine from Swift or C/Obj-C. Had some extra time to do the wheels as well.įinal photos of the Swift after all the work:Ĭheck out BHPian comments for more insights and information.You could receive the raw PCM a number of ways (in AV Foundation: AVCaptureAudioDataOutput from an AVCaptureDevice, or AVAudioEngine with a processing tap inserted in Audio Toolbox: Audio Queue Services, the RemoteIO audio unit), then to write the file, you could use Audio Toolbox's AudioFile or ExtAudioFile, just counting up how many frames you've written and deciding when it's time to start a new 8 sec file.Īs Rhythmic Fistman notes above, it would be safer if you did something likeĬapture callbacks -pushes-to-> ring buffer <-pulls-from- file-writing codeīecause when you're closing one file and opening another, the capture callbacks are still going to be coming in, and if you block on file I/O you stand a very good chance of dropping some data on the floor. The carpet was vacuumed well and the flooring was also checked and cleaned where required. I used normal detergent and water for cleaning. Started by dismantling the seats to thoroughly clean them as well. I take up this job when I have excess time on my hands and my elder cousin sister also assists me with this. The condenser was thoroughly washed after this and it looked like a new unit. In Mixer Mode, AudioSwift is currently supported with Logic Pro, Pro Tools, Ableton Live, Reaper, Cubase, Studio One and Bitwig Studio. Sprayed it after dilution with water onto the condenser and a LOT of gunk foamed up and came out. Removed the front bumper and got to work, It’s a very strong solution so dilution is recommended. Ordered TetraClean Alkaline AC Coil Cleaner for this job. The ac condenser was never cleaned In its lifetime, decided to give this a go. I’m sure the Sound quality will further improve if the car is damped. Dad was also very impressed with the sound quality.These infinity components have the perfect Highs, mids and have a good tight bass. The change in the Sound quality was DAY&NIGHT difference over the old speakers. ![]() Started the installation around 6PM and was done by midnight ! ![]() I took my own sweet time as it was a weekend. My younger cousin brother was more than happy to assist me with the install. Installed the tweeters on the sail trim and mounted the crossover with VHB tape under the sail trim behind the door pad. The old door stopper was also replaced as it had worn out. Making sure the Door panel drain holes are clear from any debris is very important as well, if not it can lead to rusting from the inside and its not a situation you want yourself to be in. While I was at this, I also inspected the window winder mechanism, cleaned it from debris and greased it. Thoroughly washed the inside carefully and mounted the spacers, crimped the new terminals and installed the speaker whilst sandwiching the foam tape between the speaker and the spacer. The darn screws also were so badly rusted that I had to tear of the spacers and unscrew them with pliers from the back YEEEESH ! sanded down those rusted areas till bare metal, wiped it down with IPA and then after drying, spray painted those spots with black paint. The old speaker spacers were MDF Spacers from 2006 which were TOASTED ! those spacers were also the cause of small rust spots. It required quite a bit of cleaning as lot of dust had accumulated. Started by removing the door pads carefully and inspected the door panel and removed the speakers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |